Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
THE HAND THROTTLE CABLE CAN WEAR THE BRASS SWIVEL BLOCK ON THE GOVERNOR LEVER THROUGH WHICH IT PASSES.
THE HAND THROTTLE CABLE CAN WEAR THE BRASS SWIVEL BLOCK ON THE GOVERNOR LEVER THROUGH WHICH IT PASSES.
THE HAND THROTTLE CABLE CAN WEAR THE BRASS SWIVEL BLOCK ON THE GOVERNOR LEVER THROUGH WHICH IT PASSES.
AS A RESULT OF INHERENT VIBRATION IN THESE ENGINES, THE THROTTLE RETURN SPRINGS CAN FRACTURE.
AS A RESULT OF INHERENT VIBRATION IN THESE ENGINES, THE THROTTLE RETURN SPRINGS CAN FRACTURE.
SECONDARY SERVICE RESERVOIR AIR CHECK VALVES MAY NOT SEAT PROPERLY DUE TO A MECHANICAL INTERFERENCE CONDITION BETWEEN A CIRCULAR BRASS GUIDE AND THE WALL OF A CYLINDRICAL FERRULE IN WHICH THE BRASS GUIDE IS INTENDED TO MOVE FREELY.
SECONDARY SERVICE RESERVOIR AIR CHECK VALVES MAY NOT SEAT PROPERLY DUE TO A MECHANICAL INTERFERENCE CONDITION BETWEEN A CIRCULAR BRASS GUIDE AND THE WALL OF A CYLINDRICAL FERRULE IN WHICH THE BRASS GUIDE IS INTENDED TO MOVE FREELY.
SOME OF THE SUSPECT VEHICLES MAY HAVE BEEN PRODUCED WITH THE POSITIVE BATTERY CABLE INCORRECTLY INDEXED AT THE ATTACHMENT TO THE STARTER SOLENOID. CABLE INSULATION DAMAGE COULD OCCUR DUE TO METAL ON METAL CONTACT DURING MAXIMUM ENGINE ROLL CONDITIONS. AN ELECTRICAL SHORT MAY DEVELOP BETWEEN THE BATTERY CABLE AND A BRAKE TUBE. A HOLE COULD BE FORMED IN THE BRAKE TUBE, RESULTING IN LOSS OF BRAKE FLUID AND REDUCED BRAKING CAPABILITY.
THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH IMPROPERLY MANUFACTURED FRONT SPRING U-BOLTS USED TO SECURE THE FRONT AXLE ASSEMBLY TO THE SPRING. THE FOUR U-BOLTS MAY EXPERIENCE CRACKS AND COULD ULTIMATELY BREAK. SHOULD TWO U-BOLTS ON THE SAME SIDE OF THE VEHICLE BREAK, THE FRONT AXLE WOULD NOT BE RETAINED SECURELY.
