Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
ON CERTAIN HEAVY DUTY CLASS 8 TRUCKS WITH VOLVO B-RIDE REAR SUSPENSION, THE FORWARD AND/OR REAR DRIVE AXLE UPPER AXLE SEAT COULD BREAK ALLOWING THE AFFECTED AXLE TO SHIFT OUT OF ALIGNMENT.
VEHICLE DESCRIPTION: HEAVY DUTY, CLASS 8, TRUCKS EQUIPPED WITH TIE ROD ASSEMBLIES CONTAINING 24-DL MODEL BALL SOCKETS AND MANUFACTURED BY TRW. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.
VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AFTERMARKET ALUMINUM DUAL WHEELS, 22.5X8.25, ONE-PIECE, TUBELESS, SUPPLIED BY ACCURIDE/AKW. CERTAIN DESIGN REVISIONS COMBINED WITH PROCESS CONDITIONS CAUSED FATIGUE CRACKS IN THESE WHEELS.
VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCKS. THE STEER AXLE WHEEL BEARING JAM NUT LOCK WASHER MAY NOT HAVE BEEN BENT OVER THE JAM NUT AFTER THE WHEEL BEARINGS WERE ADJUSTED.
THE TILT CAB, WHEN RAISED TO ITS FULLEST UP POSITION, CAN CAUSE THE STEERING SHAFT TO BIND AGAINST THE STEERING GEAR.
