Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
THE AUTOMATIC SPEED CONTROL SWITCH MAY STICK IN THE RESUME POSITION RESTRICTING RETURN MOVEMENT. THIS WILL NOT ALLOW THE NORMAL BRAKE PEDAL OPERATION TO DEACTIVATE THE SYSTEM.
THE AUTOMATIC SPEED CONTROL SWITCH MAY STICK IN THE RESUME POSITION RESTRICTING RETURN MOVEMENT. THIS WILL NOT ALLOW THE NORMAL BRAKE PEDAL OPERATION TO DEACTIVATE THE SYSTEM.
ENGINE MAY LOSE POWER OR STALL DUE TO CARBURETOR FLOODING. THIS IS CAUSED BY A POOR ELECTRICAL GROUND ON THE CARBURETOR FUEL BOWL VENT SOLENOID. VEHICLES MAY ALSO HAVE DRIVEABILITY PROBLEMS WHILE THE ENGINE IS WARMING UP IN COLD WEATHER. THESE PROBLEMS INCLUDE ENGINE MISSING, SAGS, AND HESITATION. THIS IS CAUSED BY A STICKING CARBURETOR OXYGEN FEEDBACK SOLENOID.
VEHICLES MAY NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT. ON CERTAIN VEHICLES, THE FRONT PARK AND TURN SIGNAL LAMPS MAY CONTAIN INCORRECT LAMP BULB SOCKET ASSEMBLIES. ENGINEERING TESTING DETERMINED THAT THESE LAMPS DO NOT PRODUCE A SUFFICIENT AMOUNT OF LIGHT.
INCREASED FRICTION EXPERIENCED IN OPERATION OR SERVICING OF THE SYSTEM MAY RESULT IN A TOTAL FRICTION LEVEL EXCEEDING THE FORCE CAPABILITY OF THE THROTTLE RETURN SPRINGS. THIS MAY PREVENT THE THROTTLE FROM RETURNING PROPERLY TO A CLOSED POSITION WHEN THE ACCELERATOR PEDAL IS RELEASED.
THE DEFECT INVOLVES THE POTENTIAL FOR EXHAUST GAS (CONTAINING CARBON MONOXIDE) ENTRY INTO THE PASSENGER COMPARTMENT WHICH CAN OCCUR AS A RESULT OF IMPROPERLY RETAINED PLASTIC SEALING PLUGS IN THE REAR QUARTER PANEL/TRUNK AREA OF THE VEHICLE. CARBON MONOXIDE IS A TOXIC GAS WHICH IN SUFFICIENT QUANTITY AND EXPOSURE TIME IS POTENTIALLY LETHAL.
WHEN THE ACCELERATOR PEDAL ON THE INVOLVED VEHICLES IS DEPRESSED AND THE ACCELERATOR PUMP IS ACTIVATED, A DISTORTED ACCELERATOR PUMP SEAL IN THE CARBURETOR MAY PREVENT THE PUMP FROM DELIVERING THE PROPER AMOUNT OF FUEL.
WHEN THE ACCELERATOR PEDAL ON THE INVOLVED VEHICLES IS DEPRESSED AND THE ACCELERATOR PUMP IS ACTIVATED, A DISTORTED ACCELERATOR PUMP SEAL IN THE CARBURETOR MAY PREVENT THE PUMP FROM DELIVERING THE PROPER AMOUNT OF FUEL.
WHEN THE ACCELERATOR PEDAL ON THE INVOLVED VEHICLES IS DEPRESSED AND THE ACCELERATOR PUMP IS ACTIVATED, A DISTORTED ACCELERATOR PUMP SEAL IN THE CARBURETOR MAY PREVENT THE PUMP FROM DELIVERING THE PROPER AMOUNT OF FUEL.
THE COLUMNS MAY CONTAIN STEERING SHAFTS IN WHICH THE STEERING COLUMN COUPLING ROLL PIN RETAINING NOTCH WAS MACHINED TOO DEEP. THIS MAY CAUSE THE STEERING WHEEL SHAFT TO BECOME DISENGAGED FROM THE REST OF THE STEERING ASSEMBLY.
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, SEATING SYSTEMS. THE SELF-LOCKING LATCH THAT RETAINS THE DRIVERS SEAT IN ITS UPRIGHT POSITION UNDER VEHICLE IMPACT CONDITIONS MAY FAIL DUE TO IMPROPER HEAT-TREATMENT.
