Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
GM IS RECALLING 42,408 MY 2008-2009 SATURN VUE VEHICLES. SOME OF THESE VEHICLES HAVE A CONDITION IN WHICH THE NUT SECURING THE POWER STEERING LINE TO THE POWER STEERING PUMP MAY LOOSEN. IF THIS WERE TO OCCUR, THERE MAY BE A POWER STEERING FLUID LEAK.
GM IS RECALLING 42,408 MY 2008-2009 SATURN VUE VEHICLES. SOME OF THESE VEHICLES HAVE A CONDITION IN WHICH THE NUT SECURING THE POWER STEERING LINE TO THE POWER STEERING PUMP MAY LOOSEN. IF THIS WERE TO OCCUR, THERE MAY BE A POWER STEERING FLUID LEAK.
GM IS RECALLING 857,735 MY 2006-2008 BUICK LUCERNE; CADILLAC DTS; HUMMER H2; MY 2007-2008 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL, SATURN OUTLOOK; AND MY 2008 BUICK ENCLAVE VEHICLES EQUIPPED WITH A HEATED WIPER WASHER FLUID SYSTEM. A SHORT CIRCUIT ON THE PRINTED CIRCUIT BOARD FOR THE WASHER FLUID HEATER MAY OVERHEAT THE CONTROL-CIRCUIT GROUND WIRE.
GM IS RECALLING 857,735 MY 2006-2008 BUICK LUCERNE; CADILLAC DTS; HUMMER H2; MY 2007-2008 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT; CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE; GMC ACADIA, SIERRA, YUKON, YUKON XL, SATURN OUTLOOK; AND MY 2008 BUICK ENCLAVE VEHICLES EQUIPPED WITH A HEATED WIPER WASHER FLUID SYSTEM. A SHORT CIRCUIT ON THE PRINTED CIRCUIT BOARD FOR THE WASHER FLUID HEATER MAY OVERHEAT THE CONTROL-CIRCUIT GROUND WIRE.
GM IS RECALLING 88,809 MY 2008 BUICK ENCLAVE, AND MY 2007-2008 GMC ACADIA AND SATURN OUTLOOK VEHICLES CURRENTLY OR PREVIOUSLY REGISTERED IN THE FOLLOWING STATES: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MONTANA, NEBRASKA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, NORTH DAKOTA, OHIO, PENNSYLVANIA, RHODE ISLAND, SOUTH DAKOTA, UTAH, VERMONT, WEST VIRGINIA, WISCONSIN, WYOMING, AND THE DISTRICT OF COLUMBIA. IF A BUILDUP OF SNOW OR ICE ON THE WINDSHIELD OR ON THE WIPERS RESTRICTS THE MOVEMENT OF THE WIPER ARM, THE WINDSHIELD WIPER LINKAGE MAY BECOME DETACHED FROM THE MOTOR SHAFT AND THE WIPERS MAY BECOME INOPERATIVE.
GM IS RECALLING 88,809 MY 2008 BUICK ENCLAVE, AND MY 2007-2008 GMC ACADIA AND SATURN OUTLOOK VEHICLES CURRENTLY OR PREVIOUSLY REGISTERED IN THE FOLLOWING STATES: ALASKA, COLORADO, CONNECTICUT, DELAWARE, IDAHO, ILLINOIS, INDIANA, IOWA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, MINNESOTA, MONTANA, NEBRASKA, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, NORTH DAKOTA, OHIO, PENNSYLVANIA, RHODE ISLAND, SOUTH DAKOTA, UTAH, VERMONT, WEST VIRGINIA, WISCONSIN, WYOMING, AND THE DISTRICT OF COLUMBIA. IF A BUILDUP OF SNOW OR ICE ON THE WINDSHIELD OR ON THE WIPERS RESTRICTS THE MOVEMENT OF THE WIPER ARM, THE WINDSHIELD WIPER LINKAGE MAY BECOME DETACHED FROM THE MOTOR SHAFT AND THE WIPERS MAY BECOME INOPERATIVE.
GM IS RECALLING 26 MY 2008 SATURN VUE VEHICLES EQUIPPED WITH A 6T70 6-SPEED AUTOMATIC TRANSMISSION. SOME OF THESE VEHICLES HAVE A CONDITION IN WHICH THE TRANSMISSION CASE SIDE BORE THAT HOLDS THE PARK PAWL PIVOT PIN MAY HAVE A CASTING POROSITY. THIS CONDITION, COUPLED WITH NORMAL OPERATING STRESSES, COULD LEAD TO FAILURE, ELIMINATING THE ABILITY TO SECURE THE TRANSMISSION IN 'PARK' POSITION.
ON CERTAIN PASSENGER VEHICLES, THE REAR AXLE PINION SEAL DOES NOT MEET ALL OF THE SPECIFICATIONS AND MAY EXPERIENCE A FLUID LEAK.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.2L 4-CYLINDER ENGINE, LINKS IN THE ENGINE'S TIMING CHAIN CAN SEPARATE.
CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, SEATING SYSTEMS. AND STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES. THESE VEHICLES MAY HAVE ONE TO FOUR INBOARD SEAT STUD FASTENERS THAT DO NOT MEET SPECIFICATION FOR STRENGTH.
ON CERTAIN VEHICLES, THE SENSING AND DIAGNOSTIC MODULE (SDM), WHICH CONTROLS THE FUNCTION OF FRONT AIR BAGS, MAY NOT OPERATE PROPERLY. AS A RESULT, THE FRONT AIR BAGS MAY FAIL TO DEPLOY IN A FRONTAL CRASH. ALSO, THE AIR BAG WARNING LAMP ON THE INSTRUMENT PANEL MAY FAIL TO PROVIDE WARNING THAT THE SYSTEM IS INOPERATIVE.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN TRUCKS AND SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 110, TIRE SELECTION AND RIMS. THESE VEHICLES WERE SHIPPED WITH TIRE AND LOADING INFORMATION LABELS LISTING AN INACCCURATE VEHICLE CAPACITY WEIGHT.
CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 135, 'PASSENGER CAR BRAKE SYSTEMS.' TO MEET THE STANDARD, THE VEHICLE MUST NOT MOVE FOR FIVE MINUTES WHEN STOPPED ON A STEEP HILL WITH THE PARKING BRAKE APPLIED AND THE VEHICLE IN NEUTRAL (N). SOME OF THESE VEHICLES FAILED THIS TEST.
ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
ON CERTAIN SEDANS AND WAGONS, THE PLASTIC HOUSING IN THE REAR TAIL LAMP ASSEMBLY CAN BECOME DISTORTED IF THE BRAKE LAMPS REMAIN ON FOR AN EXTENDED TIME.
CERTAIN WAGONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES. THE SEAT BELT ANCHOR MAY SEPARATE FROM THE FLOOR OF THE VEHICLE BEFORE HOLDING THE REQUIRED TEST LOAD FOR THE REQUIRED TIME.
CERTAIN WAGONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES. THE SEAT BELT ANCHOR MAY SEPARATE FROM THE FLOOR OF THE VEHICLE BEFORE HOLDING THE REQUIRED TEST LOAD FOR THE REQUIRED TIME.
CERTAIN WAGONS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, SEAT BELT ASSEMBLY ANCHORAGES. THE SEAT BELT ANCHOR MAY SEPARATE FROM THE FLOOR OF THE VEHICLE BEFORE HOLDING THE REQUIRED TEST LOAD FOR THE REQUIRED TIME.
ON CERTAIN MINIVANS, THE OUTBOARD RELEASE HANDLE ON THE IMPACT-SIDE SECOND-ROW BUCKET SEAT MAY BE ACTUATED AND THE REAR LATCHES MAY UNLATCH EARLY IN A SIDE IMPACT CRASH. THIS WAS DISCOVERED IN A SIDE IMPACT TEST RUN BY GM, UNDER CONDITIONS SIMILAR TO NHTSA'S NEW CAR ASSESSMENT PROGRAM (NCAP) SIDE IMPACT TEST.
CERTAIN PASSENGER VEHICLES HAVE A CONDITION IN WHICH THE TURN SIGNAL LAMP AND DAYTIME RUNNING LAMP (DRL) ON EITHER FRONT SIDE CAN STOP WORKING BECAUSE OF LOSS OF CONTACT BETWEEN THE BULB AND SOCKET.
CERTAIN PASSENGER VEHICLES HAVE A CONDITION IN WHICH THE TURN SIGNAL LAMP AND DAYTIME RUNNING LAMP (DRL) ON EITHER FRONT SIDE CAN STOP WORKING BECAUSE OF LOSS OF CONTACT BETWEEN THE BULB AND SOCKET.
CERTAIN VEHICLES EQUIPPED WITH SUPERCHARGED 2.0L 4-CYLINDER (LSJ) ENGINE WERE BUILT WITH A FUEL FEED PIPE THAT COULD CRACK AND LEAK FUEL NEAR THE FUEL RAIL. IF FUEL LEAKS FROM THE FUEL FEED PIPE, THERE WOULD BE A NOTICEABLE FUEL ODOR AROUND THE VEHICLE.
ON CERTAIN PASSENGER VEHICLES, SOME WELDS BETWEEN THE PASSENGER'S SIDE MOTOR RAIL AND THE FRONT BUMPER BRACKET DO NOT MEET ENGINEERING SPECIFICATIONS.
