Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
THE CENTER REAR SEAT BELT ANCHOR PLATE EXHIBITS STRESS CRACKS.
THE PROTECTIVE COVER FOR THE UNDERHOOD FUSE CENTER WAS OMITTED. WITHOUT THIS COVER, THE POSITIVE TERMINAL BOLT ON THE FUSE BLOCK IS EXPOSED AND CAN CONTACT THE INSULATED NEGATIVE BATTERY CABLE. IF THE INSULATION ON THE NEGATIVE CABLE BECOMES SUFFICIENTLY WORN, AN ELECTRICAL SHORT CIRCUIT CAN OCCUR BETWEEN THE POSITIVE TERMINAL AND NEGATIVE CABLE RESULTING IN EXTREMELY HIGH CURRENT FLOW.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.
SOME OF THESE VEHICLES HAVE A STRAINED OR SEPARATED WASHER/WIPER SWITCH POWER FEED WIRE.
SOME OF THESE VEHICLES HAVE A STRAINED OR SEPARATED WASHER/WIPER SWITCH POWER FEED WIRE.
THE FRONT AND/OR REAR HAZARD WARNING LAMPS (FOUR-WAY FLASHERS) DO NOT FLASH WHEN THE HAZARD SWITCH IS ACTIVATED. THIS FAILS TO COMPLY WITH FMVSS NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
VEHICLE DESCRIPTION: 4-DOOR, 4-WHEEL DRIVE AND ALL-WHEEL DRIVE MULTI-PURPOSE PASSENGER VEHICLES. DURING DEVELOPMENT TESTING, THE PROP SHAFT CONTACTED THE INBOARD SIDE OF THE FUEL TANK ALLOWING FUEL LEAKAGE. THIS LEAKAGE WAS IN EXCESS OF THE AMOUNT PERMITTED BY FMVSS 301, FUEL SYSTEM INTEGRITY.
DURING DEPLOYMENT OF THE PASSENGER AIR BAG, THE AIR BAG FABRIC CAN SNAG ON A REINFORCEMENT INSIDE THE INSTRUMENT PANEL, CAUSING THE EXPANDING AIR BAG TO LIFT THE INSTRUMENT PANEL PAD AND THEN DEPLOY UNDER THE INSTRUMENT PANEL INSTEAD OF THROUGH THE DOOR IN THE INSTRUMENT PANEL.
THESE VEHICLES EXHIBIT A CONDITION IN WHICH A REAR SEAT BELT BUCKLE RELEASE BUTTON CAN STICK IN THE UNLATCHED (DOWN) POSITION UNDER CERTAIN CONDITIONS BECAUSE THE BUCKLE ASSEMBLY CAN MOVE INSIDE THE SEAT BELT COVER. IF THE COVER MOVES FAR ENOUGH, IT CAN CREATE AN INTERFERENCE CONDITION WITH THE LATCH RELEASE BUTTON. WHEN IT DOES, THE SEAT BELT BUCKLE CANNOT BE LATCHED.
A BACKFIRE DURING ENGINE STARTING CAN CAUSE BREAKAGE OF THE UPPER INTAKE MANIFOLD.
A BACKFIRE DURING ENGINE STARTING CAN CAUSE BREAKAGE OF THE UPPER INTAKE MANIFOLD.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.
THESE VEHICLES WERE ASSEMBLED WITH A MALFUNCTION ALARM, LIGHTING AND LOCKING (MALL) MODULE THAT CAN CONTAIN A DAMAGED CAPACITOR. IF THE CAPACITOR IS DAMAGED, THE KEY IN THE IGNITION WARNING CHIME AND THE DRIVER SEAT BELT UNBUCKLED WARNING CHIME AND INDICATOR LAMP MAY NOT WORK. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 114, THEFT PROTECTION AND FMVSS NO. 208, OCCUPANT CRASH PROTECTION. IN ADDITION, OTHER CHIME REMINDER FUNCTIONS, INTERIOR LIGHTING CONTROLS, AND POWER DOOR LOCKING FEATURES ARE ALSO AFFECTED.
THESE VEHICLES WERE ASSEMBLED WITH A MALFUNCTION ALARM, LIGHTING AND LOCKING (MALL) MODULE THAT CAN CONTAIN A DAMAGED CAPACITOR. IF THE CAPACITOR IS DAMAGED, THE KEY IN THE IGNITION WARNING CHIME AND THE DRIVER SEAT BELT UNBUCKLED WARNING CHIME AND INDICATOR LAMP MAY NOT WORK. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 114, THEFT PROTECTION AND FMVSS NO. 208, OCCUPANT CRASH PROTECTION. IN ADDITION, OTHER CHIME REMINDER FUNCTIONS, INTERIOR LIGHTING CONTROLS, AND POWER DOOR LOCKING FEATURES ARE ALSO AFFECTED.
THESE VEHICLES WERE ASSEMBLED WITH A MALFUNCTION ALARM, LIGHTING AND LOCKING (MALL) MODULE THAT CAN CONTAIN A DAMAGED CAPACITOR. IF THE CAPACITOR IS DAMAGED, THE KEY IN THE IGNITION WARNING CHIME AND THE DRIVER SEAT BELT UNBUCKLED WARNING CHIME AND INDICATOR LAMP MAY NOT WORK. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 114, THEFT PROTECTION AND FMVSS NO. 208, OCCUPANT CRASH PROTECTION. IN ADDITION, OTHER CHIME REMINDER FUNCTIONS, INTERIOR LIGHTING CONTROLS, AND POWER DOOR LOCKING FEATURES ARE ALSO AFFECTED.
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, SEAT BELT ASSEMBLY ANCHORAGES.
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, SEAT BELT ASSEMBLY ANCHORAGES.
THESE VEHICLES WERE ASSEMBLED WITH REAR OUTBOARD SAFETY BELT ANCHORAGES THAT MAY NOT WITHSTAND THE REQUIRED LOAD. THIS DOES NOT COMPLY WITH FMVSS NO.210, SEAT BELT ASSEMBLY ANCHORAGES.
