Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
A METAL SHIELD ON THE OUTSIDE OF THE PLASTIC FUEL FILLER PIPE CAN DEVELOP A STATIC ELECTRICAL CHARGE DURING REFUELING OF THE VEHICLE.
THE NUTS AND BOLTS THAT ATTACH THE REAR BRAKE ADAPTOR TO THE AXLE HOUSING FLANGE CAN LOOSEN AND EVENTUALLY SEPARATE. IF ONE OR MORE OF THE NUTS COME OFF THE BOLTS, DAMAGE TO THE PARKING BRAKE ASSEMBLY OR TO THE ANTILOCK BRAKE SYSTEM (ABS) SENSOR AND SENSOR RING (IF SO EQUIPPED) WILL OCCUR. IF ALL FOUR NUTS ON ONE END OF THE AXLE COME OFF THE BOLTS, DAMAGE TO THE BRAKE HYDRAULIC LINE OR THE PARKING BRAKE CABLE CAN OCCUR.
THE WINDSHIELDS WERE MARKED WITH A PROTOTYPE DESIGNATION AND NOT MARKED AS REQUIRED BY FMVSS NO. 205, GLAZING MATERIALS.
THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.
THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.
THE OFFSET TOE ADJUSTING PIN CAN FRACTURE UNDER CONDITIONS SUCH AS TORSIONAL LOADS, FLEXING MOTION, IMPACT LOADS, AND OVERTORQUING.
THE TRANSMISSION FLUID RUBBER TUBE CONNECTING THE TRANSMISSION TO THE TRANSMISSION OIL COOLER LOCATED IN THE RADIATOR CAN BECOME DISCONNECTED FROM THE TRANSMISSION, RESULTING IN DISCHARGE OF TRANSMISSION FLUID.
VEHICLE DESCRIPTION: TAURUS AND SABLES BUILT FROM 10-14-85 THROUGH 8-19-88, AND LINCOLN CONTINENTALS BUILT FROM 11-4-87 THROUGH 9-30-88 (EXCEPT 1989 - 1991 2.5L TAURUS AND 1989 - 1992 SHO). THE AFFECTED CARS WERE ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, AND WISCONSIN. THE BODY MOUNTS AT THE REAR CORNERS OF THE SUBFRAME, WHICH SUPPORTS THE ENGINE AND TRANSMISSION, MAY BECOME DETACHED DUE TO CORROSION OF THE SUBFRAME MOUNT RETAINING PLATE. THIS WOULD ALLOW THE REAR CORNERS OF THE SUBFRAME TO DROP.
VEHICLE DESCRIPTION: TAURUS AND SABLES BUILT FROM 10-14-85 THROUGH 8-19-88, AND LINCOLN CONTINENTALS BUILT FROM 11-4-87 THROUGH 9-30-88 (EXCEPT 1989 - 1991 2.5L TAURUS AND 1989 - 1992 SHO). THE AFFECTED CARS WERE ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, AND WISCONSIN. THE BODY MOUNTS AT THE REAR CORNERS OF THE SUBFRAME, WHICH SUPPORTS THE ENGINE AND TRANSMISSION, MAY BECOME DETACHED DUE TO CORROSION OF THE SUBFRAME MOUNT RETAINING PLATE. THIS WOULD ALLOW THE REAR CORNERS OF THE SUBFRAME TO DROP.
VEHICLE DESCRIPTION: TAURUS AND SABLES BUILT FROM 10-14-85 THROUGH 8-19-88, AND LINCOLN CONTINENTALS BUILT FROM 11-4-87 THROUGH 9-30-88 (EXCEPT 1989 - 1991 2.5L TAURUS AND 1989 - 1992 SHO). THE AFFECTED CARS WERE ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, AND WISCONSIN. THE BODY MOUNTS AT THE REAR CORNERS OF THE SUBFRAME, WHICH SUPPORTS THE ENGINE AND TRANSMISSION, MAY BECOME DETACHED DUE TO CORROSION OF THE SUBFRAME MOUNT RETAINING PLATE. THIS WOULD ALLOW THE REAR CORNERS OF THE SUBFRAME TO DROP.
THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.
ANTI-LOCK BRAKE SYSTEM CONTROLLERS DESIGNED FOR REAR WHEEL DRIVE CARS MAY HAVE BEEN INSTALLED ON THESE FRONT WHEEL DRIVE CARS..
FUEL FILLER HOSES MAY HAVE BEEN CUT PRIOR TO INSTALLATION BY A UTILITY KNIFE USED TO OPEN THE SHIPPING BOX.
THE SERVICE BRAKE MASTER CYLINDER WAS NOT PROPERLY ASSEMBLED OR COULD HAVE BEEN DAMAGED BY THE EVACUATION AND FILLING OF THE BRAKE SYSTEM AT THE ASSEMBLY PLANT.
ONE OR BOTH OF THE BOLTS SECURING THE AUTOMATIC SEAT BELT RESTRAINT SYSTEM TRACKS TO THE B-PILLARS WERE NOT ADEQUATELY TIGHTENED.
FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.
THE RIGID MOUNTED SAFETY BELT BUCKLES ARE DEFECTIVE IN THREE WAYS. FIRST, A FASTENED SAFETY BELT BUCKLE WILL NOT UNLATCH WHEN THE RELEASE BUTTON IS DEPRESSED. THIS RESULTS FROM INTERFERENCE BETWEEN THE BUCKLE EJECTOR FINGER AND THE BUCKLE TONGUE WINDOW. THE SECOND DEFECT IS THE SAFETY BELT BUCKLE MAY NOT LATCH. THE THIRD POSSIBLE DEFECT IS THAT THE TONGUE MAY BE RETAINED BY THE BUCKLE, BUT IT MAY NOT BE LATCHED SUFFICIENTLY TO PROVIDE OCCUPANT PROTECTION.
THE RIGID MOUNTED SAFETY BELT BUCKLES ARE DEFECTIVE IN THREE WAYS. FIRST, A FASTENED SAFETY BELT BUCKLE WILL NOT UNLATCH WHEN THE RELEASE BUTTON IS DEPRESSED. THIS RESULTS FROM INTERFERENCE BETWEEN THE BUCKLE EJECTOR FINGER AND THE BUCKLE TONGUE WINDOW. THE SECOND DEFECT IS THE SAFETY BELT BUCKLE MAY NOT LATCH. THE THIRD POSSIBLE DEFECT IS THAT THE TONGUE MAY BE RETAINED BY THE BUCKLE, BUT IT MAY NOT BE LATCHED SUFFICIENTLY TO PROVIDE OCCUPANT PROTECTION.
THE STOP LAMP SWITCHES COULD INTERMITTENTLY MALFUNCTION RESULTING IN THE STOP LAMPS NOT ILLUMINATING WHEN THE BRAKES ARE APPLIED.
THE AIR BAG MODULES DO NOT MEET THE FORD SPECIFICATIONS FOR HIGH AMBIENT TEMPERATURE PERFORMANCE.
THE AIR BAG MODULES DO NOT MEET THE FORD SPECIFICATIONS FOR HIGH AMBIENT TEMPERATURE PERFORMANCE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
CHILDREN CAN ACCIDENTALLY LOCK THEMSELVES IN THE FOOTWELL AREA OF THE REAR-FACING THIRD SEAT, OR IN THE STORAGE COMPARTMENT IN STATION WAGONS NOT EQUIPPED WITH AN OPTIONAL THIRD SEAT. ONCE THE COMPARTMENT IS CLOSED IT CANNOT BE OPENED FROM THE INSIDE.
THE PLASTIC SLEEVE IN THE FRONT SAFETY BELT TONGUE ASSEMBLY WHICH RETAINS THE LOCK BAR CAN DETERIORATE FROM PROLONGED EXPOSURE TO SUNLIGHT AND BECOME DISPLACED, CAUSING THE TONGUE TO DETACH FROM THE SAFETY BELT WEBBING.
THE PLASTIC SLEEVE IN THE FRONT SAFETY BELT TONGUE ASSEMBLY WHICH RETAINS THE LOCK BAR CAN DETERIORATE FROM PROLONGED EXPOSURE TO SUNLIGHT AND BECOME DISPLACED, CAUSING THE TONGUE TO DETACH FROM THE SAFETY BELT WEBBING.
