Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
ON CERTAIN SPORT UTILITY VEHICLES, VIBRATION AND HEAT MAY CAUSE THE TAIL LAMP/STOP LAMP BULB TO LOOSEN IN ITS SOCKET. IF THIS OCCURS, THE BULB MAY FLICKER AND EVENTUALLY BECOME INOPERATIVE.
CERTAIN PASSENGER VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, 'ACCELERATOR CONTROL SYSTEMS.' IN HOT AMBIENT CONDITIONS, THE ACCELERATOR PEDAL ARM MAY STICK AT THE ATTACHMENT TO THE BRACKET AND NOT RETURN TO THE ENGINE IDLE POSITION WHEN THE OPERATOR LIFTS HIS FOOT FROM THE ACCELERATOR PEDAL.
ON CERTAIN PASSENGER VEHICLES, THE REAR SAFETY BELT CAN BECOME TWISTED.
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH 5.3L (RPO L59) V8 ENGINES, THE ENGINE FUEL RAIL CROSSOVER TUBE RETAINER SCREWS WERE NOT MANUFACTURED TO SPECIFICATIONS AND MAY BREAK.
ON CERTAIN SPORT UTILITY VEHICLES AND PICKUP TRUCKS EQUIPPED WITH 5.3L (RPO L59) V8 ENGINES, THE ENGINE FUEL RAIL CROSSOVER TUBE RETAINER SCREWS WERE NOT MANUFACTURED TO SPECIFICATIONS AND MAY BREAK.
CERTAIN VANS WERE BUILT WITH A TRANSMISSION SHIFT CABLE ASSEMBLY THAT MAY SEPARATE. IF THE CABLE ASSEMBLY SEPARATES, THE TRANSMISSION SHIFT LEVER POSITION AND THE TRANSMISSION INDICATOR MAY NO LONGER CORRELATE.
CERTAIN SPORT UTILITY VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 114, 'THEFT PROTECTION.' AN IGNITION KEY PARK LOCK CABLE END FITTING WAS NOT FULLY SEATED ON THE AUTOMATIC TRANSMISSION SHIFTER NAIL HEAD DURING INSTALLATION.
CERTAIN PASSENGER VEHICLES MAY HAVE BEEN BUILT WITH A FUEL TANK THAT DOES NOT MEET SPECIFICATION. A WELD ON THESE FUEL TANKS MAY BE INSUFFICIENT, RESULTING IN A FUEL LEAK.
CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, 'SEAT BELT ASSEMBLY ANCHORAGES.' THE PASSENGER-SIDE REAR SAFETY BELT MAY HAVE BEEN INSTALLED WITH AN INCORRECT NUT AND BOLT.
CERTAIN PASSENGER VEHICLES WERE PRODUCED WITH LOWER THAN SPECIFIED TORQUE ON BOTH FRONT BRAKE CALIPER TO STEERING KNUCKLE ATTACHMENT BOLTS. WITH IMPROPER TORQUE, THE CLAMP LOAD AT THE JOINT MAY NOT BE ADEQUATE TO PREVENT MOVEMENT BETWEEN THE CALIPER BRACKET AND KNUCKLE.
CERTAIN PASSENGER VEHICLES WERE PRODUCED WITH LOWER THAN SPECIFIED TORQUE ON BOTH FRONT BRAKE CALIPER TO STEERING KNUCKLE ATTACHMENT BOLTS. WITH IMPROPER TORQUE, THE CLAMP LOAD AT THE JOINT MAY NOT BE ADEQUATE TO PREVENT MOVEMENT BETWEEN THE CALIPER BRACKET AND KNUCKLE.
ON CERTAIN PASSENGER VEHICLES INVOLVED IN THIS CAMPAIGN, THE LOWER CONTROL ARM BALL STUD NUT/WASHER ASSEMBLIES WITH WASHERS WERE MADE OF THE WRONG MATERIAL. THE WASHERS MAY FRACTURE AND BECOME LOOSE OR FALL AWAY FROM THE VEHICLE, REDUCING CLAMP LOAD. SEPARATION OF THE CONTROL ARM BALL STUD AND STEERING KNUCKLE, DUE TO DISENGAGEMENT OF THE TAPERED ATTACHMENT AND RETAINING NUT, IS POSSIBLE.
CERTAIN EXTENDED AND REGULAR CAB PICKUP TRUCKS AND CARGO VANS CONVERTED TO COMPRESSED NATURAL GAS (CNG) FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, 'CHILD RESTRAINT ANCHORAGE SYSTEMS.' THESE VEHICLES HAVE ONE SEATING POSITION, THE CENTER REAR SEAT, EQUIPPED WITH CHILD RESTRAINT LOWER ANCHORAGES.
CERTAIN EXTENDED AND REGULAR CAB PICKUP TRUCKS AND CARGO VANS CONVERTED TO COMPRESSED NATURAL GAS (CNG) FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, 'CHILD RESTRAINT ANCHORAGE SYSTEMS.' THESE VEHICLES HAVE ONE SEATING POSITION, THE CENTER REAR SEAT, EQUIPPED WITH CHILD RESTRAINT LOWER ANCHORAGES.
CERTAIN EXTENDED AND REGULAR CAB PICKUP TRUCKS AND CARGO VANS CONVERTED TO COMPRESSED NATURAL GAS (CNG) FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 225, 'CHILD RESTRAINT ANCHORAGE SYSTEMS.' THESE VEHICLES HAVE ONE SEATING POSITION, THE CENTER REAR SEAT, EQUIPPED WITH CHILD RESTRAINT LOWER ANCHORAGES.
CERTAIN LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. ONE OF THE TWO SENSORS IN THE DRIVER'S AND FRONT PASSENGER'S SEAT BELT RETRACTORS COULD BE INOPERATIVE. THE SEAT BELT RETRACTORS WILL LOCK WHEN THE BELT WEBBING IS EXTRACTED DURING A CRASH; HOWEVER, THE MECHANISM THAT LOCKS THE SEAT BELT RETRACTOR WHEN THE VEHICLE DECELERATES QUICKLY, SUCH AS HEAVY BRAKING, MAY NOT OPERATE AS INTENDED.
CERTAIN VANS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, SEAT BELT ASSEMBLIES. THESE VEHICLES MAY HAVE BEEN PRODUCED WITH SEAT BELT BUCKLE ASSEMBLIES CONTAINING A LATCH WITH A BRITTLE CONDITION THAT MAY NOT WITHSTAND THE FORCE REQUIREMENTS OF THE STANDARD.
SOME OF THESE PASSENGER VEHICLES HAVE AN ELECTRONIC CONTROL UNIT (ECU) THAT MAY CALCULATE A HIGHER THAN ACTUAL VEHICLE SPEED BECAUSE OF AN ERRATIC REAR-WHEEL SPEED SENSOR SIGNAL, AND CAUSE ABS ACTIVATION WHERE IT IS NOT NEEDED OR NEEDED ABS ACTIVATION TO BE EXTENDED DURING BRAKING AS THE VEHICLE SPEED DROPS TO ABOUT 3 MPH.
ON CERTAIN PASSENGER VEHICLES, ANALYSIS OF AN A SIDE IMPACT CRASH TEST CONDUCTED BY THE NHTSA;S NEW CAR ASSESSMENT PROGRAM (NCAP) INDICATED THAT THE OUTBOARD ANCHORAGE OF THE DRIVER'S SEAT BELT COULD DISCONNECT BECAUSE OF CONTACT BETWEEN THE SEAT TRIM AND THE ANCHORAGE CONNECTOR WHEN THE SEAT WAS ADJUSTED TO ITS LOWEST POSITION.
CERTAIN MINIVANS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 213, CHILD RESTRAINT SYSTEMS. THESE VEHICLES DO NOT HAVE TEXT AND FORMATTING ON THE WARNING LABEL ATTACHED TO THE AVAILABLE SECOND-ROW INTEGRAL CHILD RESTRAINT AS SPECIFIED BY AMENDMENTS TO THE STANDARD.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
AFTERMARKET PICKUP TRUCK OVER-THE-RAIL BEDLINERS MANUFACTURED FOR INSTALLATION ON 1999-2004 CHEVROLET SILVERADO AND GMC SIERRA PICKUP TRUCKS. THE TOGGLE WING ASSEMBLY USED TO ATTACH THE BEDLINER TO THE TRUCK BED IS NOT ENGAGING FULLY IN THE STAKE POCKET OF THE PICKUP TRUCK.
CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
CERTAIN PICKUP TRUCKS AND SPORT UTILITY VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
