Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.
THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE PARK POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR.
THE SHIFT INDICATOR MAY NOT ACCURATELY REFLECT THE SHIFT SELECTOR POSITION. SOME VEHICLES WERE PRODUCED WITH TRANSMISSION CONTROL SELECTOR TUBE RETAINING CLIPS THAT MAY NOT BE HARD ENOUGH. THE CLIP MAY LOOSEN OR FALL OFF, AND THE SELECTOR TUBE MAY BECOME DISPLACED.
DEFECTIVE AUTOMATIC HEADLAMP DIMMER RELAYS WERE INSTALLED IN THE AFFECTED VEHICLES. THE CONTACTS ARE SUBJECT TO DETERIORATION WHICH MAY RESULT IN LOSS OF HIGH OR LOW BEAMS, OR POSSIBLY BOTH.
SOME OF THE INVOLVED VEHICLES HAVE ELECTRICAL RELAY SYSTEMS WHICH MAY BE SUSCEPTIBLE TO WATER LEAKAGE INTO THE RELAY CASE. WATER ENTRY MAY CAUSE A SHORT CIRCUIT WITHIN THE RELAY.
THE INVOLVED VEHICLES MAY START IN REVERSE GEAR. THIS DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 102, TRANSMISSION SHIFT LEVER SEQUENCE, STARTER INTERLOCK, AND TRANSMISSION BRAKING AFFECT. SOME OF THESE VEHICLES MAY BE EQUIPPED WITH A DEFECTIVE NEUTRAL START SWITCH THAT OCCASIONALLY PERMITS ENGINE STARTING WITH THE TRANSMISSION SHIFT LEVER IN THE REVERSE (R) POSITION.
STOP LAMP SWITCHES ON CERTAIN VEHICLES MAY HAVE BEEN CONTAMINATED WITH OIL, WHICH COULD DEGRADE THE CONTACTS AND RESULT IN A LOSS OF STOP LAMP FUNCTION.
THE ACCESSORY FEED WIRE ASSEMBLY MAY HAVE BEEN PINCHED BENEATH A MOUNTING BOLT BY THE CLIMATE CONTROL AIR DUCT ASSEMBLY. IF THIS CONDITION EXISTS, A HIGH RESISTANCE SHORT MAY OCCUR AND CAUSE THE WIRE TO OVERHEAT.
