Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
INADEQUATE HEAT SHIELD ABOVE CATALYTIC CONVERTER COULD OVERHEAT.
INADEQUATE HEAT SHIELD ABOVE CATALYTIC CONVERTER COULD OVERHEAT.
INADEQUATE HEAT SHIELD ABOVE CATALYTIC CONVERTER COULD OVERHEAT.
RETURN FUEL LINE HOSE MAY NOT BE OZONE RESISTANT.
THE PROTECTIVE SLEEVE COVERING OF THE RETURN FUEL HOSE BETWEEN THE PRESSURE REGULATOR AND FUEL RETURN PIPE WAS SHORTENED LEAVING PART OF THE HOSE EXPOSED. IN SOME INSTANCES THIS PART OF THE HOSE BECOMES KINKED DUE TO THE ENGINE COMPARTMENT HEAT AND/OR THE ROUTING OF THE HOSE. CONSEQUENCE OF DEFECT: IF THIS OCCURS IT COULD RESTRICT AND DAMAGE THE RETURN FUEL HOSE WHICH COULD LEAD TO FUEL LEAKAGE AND CAUSE AN ENGINE COMPARTMENT FIRE.
REAR SPRING PLATES MAY NOT HAVE BEEN TEMPERED AND ARE NOT OF THE PROPER HARDNESS VALUE. CONSEQUENCE OF DEFECT: THE PLATES COULD CRACK AND/OR BREAK, AFFECT LATERAL GUIDANCE OF THE REAR WHEEL, AND RESULT IN LOSS OF CONTROL OF THE CAR WHICH MAY CAUSE AN ACCIDENT.
REAR SPRING PLATES MAY NOT HAVE BEEN TEMPERED AND ARE NOT OF THE PROPER HARDNESS VALUE. CONSEQUENCE OF DEFECT: THE PLATES COULD CRACK AND/OR BREAK, AFFECT LATERAL GUIDANCE OF THE REAR WHEEL, AND RESULT IN LOSS OF CONTROL OF THE CAR WHICH MAY CAUSE AN ACCIDENT.
THE ENGINE CARRIER HAS A FAULTY WELD TO THE SUPPORT BRACKET EYES. CONSEQUENCE OF DEFECT: THE WELD COULD GIVE WAY AND THE BRACKET EYE SEPARATE FROM THE CARRIER. WITH HIGHER MILEAGE ACCUMULATION A BREAK IN THE ENGINE CARRIER COULD DEVELOP AND RESULT IN A STEERING BLOCKAGE, LOSS OF CONTROL WITH POSSIBLY AN ACCIDENT.
FUEL HOSE MAY BE DAMAGED DUE TO TOO MUCH PRESSURE IN CRIMPING THE HOSE END FITTING. CONSEQUENCE OF DEFECT: A FUEL LEAK COULD DEVELOP WHICH COULD CAUSE A LOSS IN SYSTEM PRESSURE AND ENGINE STALLING. ALSO, FUEL VAPORS IN THE ENGINE COMPARTMENT COULD BE IGNITED BY A SPARK AND CAUSE A FIRE.
METAL BUSHINGS FOR THE CRUISE CONTROL LINKAGE ARE SUBJECT TO CORROSION DUE TO WEATHER CONDITIONS. ALSO, THERE IS NOT ENOUGH CLEARANCE BETWEEN THE BUSHINGS AND THE SHAFT; AND THE LINKAGE POINTS WERE NOT LUBRICATED. THUS, CRUISE CONTROL LINKAGE CAN BIND, CAUSING THE ACCELERATOR PEDAL TO STICK IN A DEPRESSED POSITION. CONSEQUENCE OF DEFECT: THE VEHICLE, WITHOUT WARNING, WOULD CONTINUE AT SET SPEED AND CAN'T BE REDUCED. THIS COULD RESULT IN LOSS OF CONTROL AND AN ACCIDENT.
METAL BUSHINGS FOR THE CRUISE CONTROL LINKAGE ARE SUBJECT TO CORROSION DUE TO WEATHER CONDITIONS. ALSO, THERE IS NOT ENOUGH CLEARANCE BETWEEN THE BUSHINGS AND THE SHAFT; AND THE LINKAGE POINTS WERE NOT LUBRICATED. THUS, CRUISE CONTROL LINKAGE CAN BIND, CAUSING THE ACCELERATOR PEDAL TO STICK IN A DEPRESSED POSITION. CONSEQUENCE OF DEFECT: THE VEHICLE, WITHOUT WARNING, WOULD CONTINUE AT SET SPEED AND CAN'T BE REDUCED. THIS COULD RESULT IN LOSS OF CONTROL AND AN ACCIDENT.
THE REAR SEAT BELTS DO NOT INCLUDE EMERGENCY-LOCKING OR AUTOMATIC-LOCKING RETRACTORS. THE BELTS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
THE REAR SEAT BELTS DO NOT INCLUDE EMERGENCY-LOCKING OR AUTOMATIC-LOCKING RETRACTORS. THE BELTS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
THE REAR SEAT BELTS DO NOT INCLUDE EMERGENCY-LOCKING OR AUTOMATIC-LOCKING RETRACTORS. THE BELTS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
THE REAR SEAT BELTS DO NOT INCLUDE EMERGENCY-LOCKING OR AUTOMATIC-LOCKING RETRACTORS. THE BELTS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
THE REAR SEAT BELTS DO NOT INCLUDE EMERGENCY-LOCKING OR AUTOMATIC-LOCKING RETRACTORS. THE BELTS DO NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, OCCUPANT CRASH PROTECTION.
ON THE INVOLVED VEHICLES, THE UNIVERSAL JOINT WHICH CONNECTS THE STEERING SHAFT TO THE STEERING RACK MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF VEHICLE IS DRIVEN ON POOR ROADS FOR AN EXTENDED PERIOD OF TIME, THE CONNECTION BETWEEN THE STEERING SHAFT AND UNIVERSAL JOINT COULD LOOSEN AND CAUSE EXCESSIVE STEERING WHEEL FREE PLAY.
ON THE INVOLVED VEHICLES, THE UNIVERSAL JOINT WHICH CONNECTS THE STEERING SHAFT TO THE STEERING RACK MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF VEHICLE IS DRIVEN ON POOR ROADS FOR AN EXTENDED PERIOD OF TIME, THE CONNECTION BETWEEN THE STEERING SHAFT AND UNIVERSAL JOINT COULD LOOSEN AND CAUSE EXCESSIVE STEERING WHEEL FREE PLAY.
ON THE INVOLVED VEHICLES, THE UNIVERSAL JOINT WHICH CONNECTS THE STEERING SHAFT TO THE STEERING RACK MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF VEHICLE IS DRIVEN ON POOR ROADS FOR AN EXTENDED PERIOD OF TIME, THE CONNECTION BETWEEN THE STEERING SHAFT AND UNIVERSAL JOINT COULD LOOSEN AND CAUSE EXCESSIVE STEERING WHEEL FREE PLAY.
DUE TO THE IMPROPER INSTALLATION OF HYDRAULIC BRAKE HOSES, THE HOSE COULD RUB AGAINST THE RIM IN CERTAIN WHEEL POSITIONS. BRAKE FLUID LOSS COULD RESULT, CAUSING A DEGRADATION IN THE PERFORMANCE OF THE FRONT BRAKE SYSTEM. THIS WOULD CAUSE AN INCREASE IN VEHICLE STOPPING DISTANCES.
FRONT SHOCK ABSORBERS ON SOME VEHICLES MAY HAVE IMPROPERLY WELDED MOUNTING EYES. THE SHOCK ABSORBER MOUNTING COULD SEPARATE AND CAUSE THE SUSPENSION TO COLLAPSE IF VEHICLE IS DRIVEN ON ROUGH ROADS FOR A LONG PERIOD OF TIME.
FRONT SHOCK ABSORBERS ON SOME VEHICLES MAY HAVE IMPROPERLY WELDED MOUNTING EYES. THE SHOCK ABSORBER MOUNTING COULD SEPARATE AND CAUSE THE SUSPENSION TO COLLAPSE IF VEHICLE IS DRIVEN ON ROUGH ROADS FOR A LONG PERIOD OF TIME.
THE BRIDGE IN THE SEAT BELT BUCKLE LOCKING MECHANISM OF THE FRONT SEAT BELT ASSEMBLY MAY HAVE BEEN IMPROPERLY BENT. THE BUCKLE MAY NOT HOLD PROPERLY AND WILL RELEASE, IF EXTREME FORCES ARE APPLIED.
THE BRIDGE IN THE SEAT BELT BUCKLE LOCKING MECHANISM OF THE FRONT SEAT BELT ASSEMBLY MAY HAVE BEEN IMPROPERLY BENT. THE BUCKLE MAY NOT HOLD PROPERLY AND WILL RELEASE, IF EXTREME FORCES ARE APPLIED.
THE SURFACE OF THE MOUNTING BOLTS CONNECTING THE OUTER CONSTANT VELOCITY JOINT TO THE LEFT AND RIGHT AXLE SHAFTS ON THE REAR OF THE CAR MAY HAVE BEEN IMPROPERLY TREATED. AS A RESULT, THE HEAD OF THE BOLT MAY HAVE BEEN SCUFFED DURING INSTALLATION AND MAY NOT HAVE THE PROPER TORQUE. BOLTS MAY BECOME LOOSE AND AXLE SHAFT SEPARATION COULD OCCUR.
THE TWO MOUNTING BOLTS FOR EACH OF THE LEFT AND RIGHT SIDE FRONT CALIPERS HAVE BEEN IMPROPERLY TORQUED DURING ASSEMBLY. THE TORQUE WRENCH USED IN THE ASSEMBLY MAY HAVE BEEN MECHANICALLY DEFECTIVE.
THE BRAKE SYSTEM RESERVOIR ON THE INVOLVED VEHICES MAY CONTAIN CONTAMINATED BRAKE FLUID. THIS FLUID COULD EVENTUALLY SPREAD THROUGH THE COMPLETE BRAKE SYSTEM AND DAMAGE BRAKE COMPONENTS.
ON THE INVOLVED VEHICLES THE ELECTRICAL WIRING HARNESS LEADING TO THE STARTER AND BACK-UP LIGHT SWITCH MAY HAVE BEEN IMPROPERLY ROUTED. THE HARNESS MAY CHAFE AGAINST THE FRONT ENGINE SHROUDING EVENTUALLY RESULTING IN INSULATION DAMAGE, WHICH CAN CREATE AN ELECTRICAL SHORT.
THE SYMBOL IDENTIFYING THE LIGHT SWITCH ON THE INVOLVED VEHICLES DOES NOT MEET THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 101, CONTROL AND DISPLAYS.
CERTIFICATION LABELS INSTALLED IN THE INVOLVED VEHICLES MAY NOT INCLUDE THE DATE OF VEHICLE MANUFACTURE, AS REQUIRED BY FEDERAL REGULATIONS.
