Just What Is a Car Recall? Car Safety Recall Definition - A safety recall is an automotive manufacturer's way of notifying vehicle customers that their product has a flaw. The automobile problem is serious enough that if you do not correct the flaw your and/or your passengers' safety could be at risk. Generally recalls are initiated by the US Government, but sometimes individual car manufacturers will pre-emptively initiate a recall.
Where Do I Find My VIN (Vehicle Identification Number)? Look on the lower left of your car’s windshield for your 17-digit Vehicle Identification Number (VIN). Your VIN is also located on your car’s registration card, and it may be shown on your insurance card.
Auto Tip - How Do I Find Out If My Vehicle Has A Recall? ==> An easy way to determine if you have an active car recall is to just enter your VIN number at the top of this page and CarFax will report if there are any issues at all with your vehicle.
ORIGINAL PRODUCTION TRANSMISSION LUBRICANT USED IN THE INVOLVED VEHICLES MAY NOT PROVIDE ADEQUATE LUBRICATION TO PROTECT THE TRANSMISSIONS FIRST GEAR.
ORIGINAL PRODUCTION TRANSMISSION LUBRICANT USED IN THE INVOLVED VEHICLES MAY NOT PROVIDE ADEQUATE LUBRICATION TO PROTECT THE TRANSMISSIONS FIRST GEAR.
ORIGINAL PRODUCTION TRANSMISSION LUBRICANT USED IN THE INVOLVED VEHICLES MAY NOT PROVIDE ADEQUATE LUBRICATION TO PROTECT THE TRANSMISSIONS FIRST GEAR.
ORIGINAL PRODUCTION TRANSMISSION LUBRICANT USED IN THE INVOLVED VEHICLES MAY NOT PROVIDE ADEQUATE LUBRICATION TO PROTECT THE TRANSMISSIONS FIRST GEAR.
THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.
THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.
THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.
THE TRANSMISSION THROTTLE CONTROL ROD SPRING MAY HAVE BEEN IMPROPERLY INSTALLED. THIS MAY CAUSE THE THROTTLE TO CLOSE MORE SLOWLY THAN NORMAL. VEHICLES MAY RETURN TO IDLE SLOWLY.
SOME OF THE INVOLVED VEHICLES WERE ASSEMBLED WITH TONGUE-END REAR SEAT BELT ASSEMBLIES INSTEAD OF THE BUCKLE END AND TONGUE-END ASSEMBLIES. WITHOUT THE BUCKLE END ASSEMBLIES, THE REAR SEAT BELTS CANNOT BE FASTENED.
SOME OF THE INVOLVED VEHICLES WERE ASSEMBLED WITH TONGUE-END REAR SEAT BELT ASSEMBLIES INSTEAD OF THE BUCKLE END AND TONGUE-END ASSEMBLIES. WITHOUT THE BUCKLE END ASSEMBLIES, THE REAR SEAT BELTS CANNOT BE FASTENED.
SOME OF THE INVOLVED VEHICLES WERE ASSEMBLED WITH TONGUE-END REAR SEAT BELT ASSEMBLIES INSTEAD OF THE BUCKLE END AND TONGUE-END ASSEMBLIES. WITHOUT THE BUCKLE END ASSEMBLIES, THE REAR SEAT BELTS CANNOT BE FASTENED.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
THE RIGHT AND LEFT REAR WHEEL BEARINGS MAY HAVE BEEN DAMAGED DURING ASSEMBLY. A DAMAGED BEARING COULD RESULT IN AXLE AND WHEEL DISENGAGEMENT FROM THE VEHICLE WHILE IN MOTION.
INCORRECT HEADLAMPS MAY HAVE BEEN INSTALLED ON THE INVOLVED VEHICLES. THESE HEADLAMPS HAVE BEEN APPROVED FOR EXPORT ONLY AND DO NOT MEET U.S. REQUIREMENTS.
INCORRECT HEADLAMPS MAY HAVE BEEN INSTALLED ON THE INVOLVED VEHICLES. THESE HEADLAMPS HAVE BEEN APPROVED FOR EXPORT ONLY AND DO NOT MEET U.S. REQUIREMENTS.
INCORRECT HEADLAMPS MAY HAVE BEEN INSTALLED ON THE INVOLVED VEHICLES. THESE HEADLAMPS HAVE BEEN APPROVED FOR EXPORT ONLY AND DO NOT MEET U.S. REQUIREMENTS.
SOME OF THE INVOLVED VEHICLES MAY HAVE INCORRECT UNIVERSAL JOINT FASTENERS. THESE FASTENERS MAY LOOSEN AND ALLOW THE PROPELLER SHAFT TO DISCONNECT FROM THE AXLE OR TRANSFER CASE.
SOME OF THE INVOLVED VEHICLES MAY HAVE INCORRECT UNIVERSAL JOINT FASTENERS. THESE FASTENERS MAY LOOSEN AND ALLOW THE PROPELLER SHAFT TO DISCONNECT FROM THE AXLE OR TRANSFER CASE.
CERTAIN VEHICLES MAY HAVE AN INCORRECT GASKET BETWEEN THE TRANSMISSION AND THE TRANSFER CASE. AN INCORRECT GASKET MAY INTERFERE WITH THE NORMAL FLOW OF LUBRICANT. THIS CONDITION COULD CAUSE THE TRANSMISSION TO BECOME DAMAGED AND INOPERATIVE.
CERTAIN VEHICLES MAY HAVE AN INCORRECT GASKET BETWEEN THE TRANSMISSION AND THE TRANSFER CASE. AN INCORRECT GASKET MAY INTERFERE WITH THE NORMAL FLOW OF LUBRICANT. THIS CONDITION COULD CAUSE THE TRANSMISSION TO BECOME DAMAGED AND INOPERATIVE.
THE THROTTLE LINKAGE CONTROL SPRING MAY NOT CLOSE RAPIDLY WHEN THE ACCELERATOR PEDAL IS RELEASED. IF THE THROTTLE DOES NOT CLOSE AS RAPIDLY AS EXPECTED, THE VEHICLE WILL NOT DECELERATE PROPERLY. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.124, ACCELERATOR CONTROL SYSTEMS.
THE THROTTLE LINKAGE CONTROL SPRING MAY NOT CLOSE RAPIDLY WHEN THE ACCELERATOR PEDAL IS RELEASED. IF THE THROTTLE DOES NOT CLOSE AS RAPIDLY AS EXPECTED, THE VEHICLE WILL NOT DECELERATE PROPERLY. THIS FAILS TO COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO.124, ACCELERATOR CONTROL SYSTEMS.
THE CLAMP BOLTS ON THE ADJUSTER TUBE THAT FASTENS THE CONNECTING ROD TO THE PITMAN ARM END ASSEMBLY MAY BE LOOSE. THESE LOOSE BOLTS COULD CAUSE SHIFTING OF THE STEERING WHEEL POSITION, RELATIVE TO THE STRAIGHT-AHEAD-FRONT WHEEL POSITION, AND LOSS OF STEERING.
THE CLAMP BOLTS ON THE ADJUSTER TUBE THAT FASTENS THE CONNECTING ROD TO THE PITMAN ARM END ASSEMBLY MAY BE LOOSE. THESE LOOSE BOLTS COULD CAUSE SHIFTING OF THE STEERING WHEEL POSITION, RELATIVE TO THE STRAIGHT-AHEAD-FRONT WHEEL POSITION, AND LOSS OF STEERING.
VEHICLES WERE BUILT WITH WIRE CONNECTORS THAT FAIL TO ALLOW THE CURRENT FLOW NEEDED TO SUPPORT THE ELECTRONIC CONTROL OF THE ENGINE IGNITION.
VEHICLES WERE BUILT WITH WIRE CONNECTORS THAT FAIL TO ALLOW THE CURRENT FLOW NEEDED TO SUPPORT THE ELECTRONIC CONTROL OF THE ENGINE IGNITION.
